Leitner Wireless Headset Mitel EHS Setup

    Support › Mitel Setup

    1. Unplug the power cord from your Leitner base
    2. Set the switches on the bottom of the base to DHSG and 1
    3. Grab the Y-cable of the EHS. Connect the single end to the AUX port on your telephone
    4. Connect larger cable of the Y-end to the AUX port on Leitner base. Smaller end goes into green TEL port on the base
    5. Plug your power cord back in
    6. *For Mitel phones, you may need to enable DHSG headset mode in your phone settings. This typically is found under "Headset" in your phone's audio settings